Die gesamte Meldung finden Sie unter folgendem Link:
Iomega stellt neue Netzwerkspeicherprodukte vor
-
-
Zitat
JBOD (zur Behandlung beider Laufwerke wie ein einziges großes Laufwerk).
Das tut RAID0 auchJBOD ist für den zusammenschluss unterschiedlich größer Festplatten gedacht und macht hier somit garkeinen Sinn !
-
doch es macht sinn zb bei einer 200gb und einer 300gb festplatte es wir dschneller als raid
-
1. wird durch jbod rein gar nix schneller und
2. hat es nix mit der größe von hdds zu tun, die spielt dabei keine rolle, denn
3. ist jbod = raid0 ohne raid ergo werden mehrere hdd zu einem lw, aber keine verbesserung der geschwindigkeit und schon gar keine in bezug auf datensicherheit bei defekt...kein speed daher, da die hdds nich parallel, sondern nacheinander beschrieben werden...
-
und wenn ich kein raid benutzen will???!!!
-
jbod != raid!
aber wenn du beide hdd einzeln nutzen willst haste meist n zappen, da dies nicht selten nicht umzuschalten geht!
-
da bei der Box (1TB) 2x500GB Platten verwendet werden und keine "200GB und eine 300GB" macht es keinen Sinn
-
immo hab ich sowieso nur 1 x 160gb auso ist raid oder sonstwas mir sowieso egal ;
-
wieso machts denn keinen sinn whoop? logisch machts einen: du hast zwei platten in nem case und wenn du die anschließt hast du nur eine...das mit den unterschiedlichen größen ist quark, denn das ist keine voraussetzung! einfach nur mehrere platten zu einer zusammengefasst, was is daran sinnlos?
-
genau du beschreibst das RAID0 verfahren wozu JBOD? bei gleichen platten.
-
was ist raid?????
-
@whoop um nur ein laufwerk zu haben, egal bei wievielen platten, aber eben OHNE geschwindigkeitsboost und OHNE die erhöhung der ausfallwahrscheinlichkeit. denn da die daten nicht gesplittet werden, kann man die daten pro hdd wiederherstellen und sie sind nicht zwingen verloren, wie bei raid0
-
hmm es ist aber genau so schlecht da nur ein Laufwerk da ist. wenn eine der Platten ausfällt ist das nicht so schlimm wie bei nem RAID0 aber ein raid0 ist mit ordentlichen controllern auch nicht unbedingt komplett verloren. Das wiederherstellen wird sich ungefähr gleich belaufen.
somit ist es nur sinnvoll bei unterschiedlichen platten da nur nachteile vorhanden sind (Wenn man ein RAID0 schalten könnte) und keinerlei "größeren" Vorteile entstehen.
-
naja eben nicht aufgrund der mechanischen ausfallgeschichte...dann sind nicht gleich alle daten auf den platten verloren...
-
auch bei einem mechanischen ausfall musst du die Platten bei JBOD "reparieren" bei RAID0 müsstest du dies auch tun Es stimmt das es bei JBOD vielleicht sogar von zu Hause aus geht aber wiederherstellen kannst du auch viel bei Raid0.
Also würde ich JBOD gleich weg lassen.
Vorteil = "Eine Platte"
Nachteil = reperatur bei ausfall einer platteDann kannst du sie auch einzeln ansteuern oder du nimmst den boost von Raid0 gleich noch mit